to the United States 
LED drivers generate heat during normal operation — some warmth is expected. But if the driver is too hot to touch or is shutting down intermittently, something is wrong. Driver overheating shortens the driver’s life and can cause flickering, reduced output, or complete shutdown. Work through this checklist.
Checklist
1. Overloaded — too many LEDs
The driver’s power dissipation increases with the total LED Forward Voltage. Driving more LEDs in series (higher total Vf) means more heat in the driver, especially when the input-to-output voltage difference is large.
Check: Count your LEDs and calculate total Vf. Is it within the driver’s rated output voltage range?
Fix: Reduce the LED count per driver, or split into multiple strings with separate drivers.
2. Input voltage too high
Buck drivers dissipate heat proportional to the difference between input and output voltage. A BuckPuck running from 32V to drive a single 3.2V LED wastes a lot of energy as heat (28.8V × current = waste power). The same driver running from 12V wastes much less.
Fix: Use a supply voltage closer to (but still above) the minimum required. If your supply is 24V and you are driving a single LED, this is inefficient by design — consider a lower-voltage supply or add more LEDs in series to use more of the input voltage productively.
3. No ventilation
Drivers need airflow to shed heat. Enclosing a driver in a sealed box with no ventilation traps heat and raises the ambient temperature around the driver.
Fix: Add ventilation holes to the enclosure, or mount the driver where it has access to free air. If a sealed enclosure is required, oversize the enclosure to provide a larger air volume as thermal mass.
4. Ambient temperature too high
Drivers are rated for a maximum ambient temperature (typically 50–70°C depending on the model). If the driver is mounted near the LED heatsink, engine compartment, or inside an unventilated outdoor enclosure in direct sun, ambient temperatures may exceed the rating.
Fix: Mount the driver away from heat sources. Separate the driver from the LED heatsink by at least a few inches.
5. Faulty driver
Rare, but a driver with a damaged component can draw excessive current and overheat.
Check: Swap in a known-good driver of the same model. If the replacement runs cool under the same conditions, the original is faulty.
Normal vs Abnormal Heat
- Warm to the touch (40–50°C surface): Normal for most drivers under load.
- Hot but touchable briefly (50–65°C surface): Acceptable at high loads but check ventilation.
- Too hot to touch / shutting down: Investigate using the checklist above.
If you are unsure whether your driver’s temperature is normal, contact us with the driver model, LED load, supply voltage, and enclosure details.
